Recent Entries

• Syringe Mould: Plastic Syringe Storage Environment

  by krista medicalmould March 23, 2020
  The plastic syringe is mainly composed of a jacket, a core rod, a piston, a positioning ring and a protective cap. It is made of imported raw materials and produced by injection moulding. This product is mainly sterilized by ethylene oxide or cobalt 60. Can effectively ensure that the product is ste...

• Effect Of Cooling System On Syringe Mould

  by krista medicalmould March 18, 2020
  The design of injection mould cooling systems is often considered a minor issue. Not enough attention has been paid to the size and structural design of the cooling system. The design of the cooling system is unreasonable, it will cause internal stress for small plastic parts, and it will cause...

• Vaginal Speculum Mould -About Vaginal Speculum Treatment

  by krista medicalmould March 9, 2020
  Vaginal Speculum treatment is usually recommended for women who experience pain and discomfort during pelvic radiotherapy or intercourse, and for women with congenital vaginal deformities. There are physical and psychological benefits to using a Vaginal Speculum; however, it often causes pain, disco...

• Vaginal Speculum Mould -Diseases Treated With Vaginal Speculum

  by krista medicalmould March 4, 2020
  Vaginal Speculum, consisting of two pages and a handle, is mainly used for routine gynecological examination and surgery. I believe that women who have undergone gynecological examinations will not be too unfamiliar with this device.   The Vaginal Speculums commonly used in surgery are usuall...

• Syringe Mould-About Preventing Mould Shrinkage Error

  by krista medicalmould February 26, 2020
  Today's Yuhuan Shengjiu Mould Co., Ltd. mainly introduces the related content of how to prevent the occurrence of the mould shrinkage error of the syringe mould: Since the shrinkage rate changes due to the injection pressure, the cavity pressure in the cavity should be as consistent as possibl...

• Solution To The Deformation Of The Syringe Mould

  by krista medicalmould February 19, 2020
  In the production of syringe moulds and products, mould materials often have various defects and distortions. One of the reasons for the deformation of the material is that, in order to reduce costs, the actual mould material is not a special mould steel, the template has insufficient...

• Disposable Syringe Mould Design: What Are The Requirements?

  by krista medicalmould February 12, 2020
  The shapes of the parts of syringe moulds are often complex and difficult to process after quenching. Therefore, it is preferable to use a material having good thermal stability. When the mould is processed, the linear expansion coefficient is small, the heat treatment deformation is small, the...