Recent Entries

• Medical Mould-Syringe Mould Cooling System Structure

  by krista medicalmould August 12, 2020
  The design of the injection mould cooling system is often regarded as a minor issue. Not enough attention has been paid to the size and structural design of the cooling system. Unreasonable cooling system design will cause internal stress for small plastic parts, and deformation and even stress...

• How To Use: Three Way Stopcock ?

  by krista medicalmould August 2, 2020
  Click on the connector with 2 female Luer ports and a male Luer lock. 3 ports have been capped. Color studs are provided, which can be fixed for color coding. Usually the faucet is blue or red, indicating venous or arterial use respectively. Some plug valves have been connected to extension pipes. ...

• Medical Mould-Mould Processing: 5 Things

  by krista medicalmould July 27, 2020
  In the process of mould processing, if you want to become an injection moulded part, then basically this process is relatively complicated. In fact, more process parameters will be considered during mould processing. Of course, these process parameters must be guaranteed. All are to meet m...

• Structural Principle Of Three Way Stopcock

  by krista medicalmould July 20, 2020
  Transparent appearance, increase the safety of infusion, and help to observe the exhaust situation; Easy to operate, can rotate 360 ​​degrees, the arrow indicates the flow direction; Does not interrupt fluid flow during conversion, does not produce vortex, and reduces thrombosis   The medic...

• Medical Mould-About Plastic Mould Processing

  by krista medicalmould July 8, 2020
  With the continuous improvement of the processing level of plastic moulds, more and more companies are able to produce plastic films with good quality. The so-called injection mould refers to a variety of processes such as compression moulding, injection moulding and blow moulding, and is used ...