Event Details

  • There are many kinds of chains, but their basic structures are only the following, and the others are all variations of these kinds. We can see from the above chain structures that most chains are composed of chainplates, chain pins, shaft sleeves, and other components. Other types of chains only change the link plates according to different requirements. Some have scraper plates installed on the link plates, some have guide bearings installed on the link plates, and some have rollers installed on the link plates. These are all modifications for different applications.

    The palm oil chain(GETECHAIN) https://www.getechain.com/product/palm-oil-chain/
    is too long or elongated after use, which is difficult to adjust. The chain links can be removed depending on the situation, but it must be even. The chain link should pass through the back of the palm oil chain, the locking piece should be inserted outside, and the opening of the locking piece should face the opposite direction of rotation. After the sprocket is seriously worn, a new sprocket and a new chain should be replaced at the same time to ensure good meshing. You cannot replace a new chain or a new sprocket alone. Otherwise, it will cause bad meshing and accelerate the wear of new chains or sprockets. When the tooth surface of the sprocket is worn to a certain extent, it should be turned over in time (referring to the sprocket with the adjustable surface). So as to prolong the service time. The old chain cannot be mixed with some new chains, otherwise, it is easy to generate impact in transmission and break palm oil chain. The palm oil chain should be filled with lubricating oil in time during work. Lubricating oil must enter the fit clearance between the roller and inner sleeve to improve working conditions and reduce wear.

    The sprocket shall be installed on the shaft without skew and swing. The end faces of the two sprockets in the same transmission assembly should be located in the same plane. When the center distance of the sprockets is less than 0 and 5 meters, the allowable deviation is 1 mm; When the sprocket center distance is more than 0 or 5 meters, the allowable deviation is 2 mm. However, friction on the side of sprocket teeth is not allowed. If the two wheels shift too much, it is easy to cause derailment and accelerated wear. Attention must be paid to checking and adjusting the offset when replacing the sprocket. The tightness of the palm oil chain should be appropriate, too tight increases power consumption, and bearings are easy to wear. The too-loose chain is easy to jump and take off. The tightness of the chain is: lift or press down from the middle of the chain, and the center distance between the two sprockets is about 2-3 cm.

    Click leaf chain https://www.getechain.com/product/leaf-chain-product/
    to learn about more information.
  • 9/4/19 at 1:00 AM -
    9/24/19 at 1:00 AM
  • Category
  • RSVPs
    • 1 attending
    • 0 maybe attending
    • 0 not attending
    • 0 awaiting reply

Updates